Error Codes (Hs / Hp); Maintenance And Cleaning - IKA C-MAG HS 4 Betriebsanleitung

Any malfunctions during operation will be identified by an error message on the display (C).
Proceed as follows in such cases:
- Whenever an error message appears switch the device off to cool down
- Carry out corrective measures
- Restart device
Error code Cause
E1 Temperature inside device too high
E6 Motor blockage
E9 Safety circuit ETC
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the service department,
- Send the device for repair, including a short description of the fault.
The device is maintenance-free.
/// Cleaning
- For cleaning disconnect the mains plug!
- Use only cleaning agents which have been approved by IKA to clean IKA devices.
These are water (with tenside) and isopropanol.
- Wear protective gloves during cleaning the devices.
- Electrical devices may not be placed in the cleansing agent for the purpose of cleaning.
- Do not allow moisture to get into the device when cleaning.
- Before using another than the recommended method for cleaning or decontamination, the user must ascertain with IKA that this
method does not destroy the device.
16

Error codes (HS / HP)

Solution
- Switch off device and allow to cool down
- Stirring bars inappropriate
- Reduce the viscosity
- Remove foreign objects in the device
- Plug the contact plug (G)
- Plug the contact thermometer
- Replace the defective connecting cable, plug or contact thermometer

Maintenance and cleaning