LaserLiner BBQ-GasCheck Bedienungsanleitung Seite 8

To measure the level
2
Place the measuring head vertically on the surface of the cylinder
and lightly press it down in this position.
Hold the measuring head steady during the measurement and only
make a slight correction if a negative visual signal (red) is indicated.
To avoid damage, do not push the measuring head over the surface.
The device switches off automatically if left idle for 2 seconds.
Signal indicator
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning
agents, scouring agents and solvents. Remove the battery(ies) before
storing for longer periods. Store the device in a clean and dry place.
08
EN
90°
BBQ-GasCheck
Blue LED
Measurement in progress
Red LED
Result: Measurement finished,
no gas found
Green LED
Result: Measurement finished,
there is gas at the current position
Lower red LED flashing
Low battery charge.
90°
BBQ-GasCheck
90°