Before Use - Hilti VC 40H-X Original Bedienungsanleitung

Maximum volumetric flow rate (air)
Maximum partial vacuum
4.4 Noise and vibration information (measured in accordance with EN 60335)
The following information applies to all VC 20 and VC 40 industrial vacuum cleaners.
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration emission value
5 Use of extension cords
▶ Use only extension cords of a type approved for the application and with conductors of adequate gauge.
Non-compliance with the above can result in the power tool losing power and/or the extension cord
overheating.
▶ Do not use extension cords with a conductor cross section of less than 1.5 mm
▶ When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
▶ Check the extension cord for damage at regular intervals.
▶ Replace damaged extension cords.
6

Before use

DANGER
Electrical hazards. Fatal or serious injury may result if the vacuum cleaner is not correctly connected to the
electric supply.
▶ Connect the vacuum cleaner only to a properly earthed/grounded power source.
CAUTION
Risk of injury presented by the appliance running away out of control. The vacuum cleaner may run
away out of control if the wheel brakes are not engaged.
▶ Engage the wheel brakes so that the vacuum cleaner stands securely.
6.1 Inserting the PE disposal bag
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Secure a new PE disposal bag in the waste material container.
5. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
6.2 Inserting/changing the dust bag (for dust class H applications)
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Close the dust bag with a cable tie positioned below the felt vent opening.
5. Remove the dust bag.
6. Clean the waste material container with a cloth.
7. Fit a new dust bag in the waste material container.
8. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
22 English
Printed: 24.07.2019 | Doc-Nr: PUB / 5505414 / 000 / 00
VC 40H-X
1100 W 134 m³/h
1200 W 146 m³/h
1100 W 229 hPa
1200 W 249 hPa
)
pA
)
pA
2
VC 40H-XE
134 m³/h
146 m³/h
229 hPa
249 hPa
73 dB(A)
2.5 dB(A)
< 2.5 m/s²
.
2
3
2243106
*2243106*