Selecting A Channel; Selecting The Ctcss Code - AUDIOLINE PMR 22 Bedienungsanleitung

Operating the Walkie-Talkies

Selecting a channel

/
Channel Frequency (MHz)
1
2
3
4

Selecting the CTCSS code

CTCSS: Continous Tone Coded Squelch System
All the calls on walkie-talkies which occur within the range of reception are
signalled. A condition for this is that all the walkie-talkies are set to the
same channel. To prevent mutual interference, a CTCSS code can be
defined for the set channel. 38 CTCSS codes can be set per channel.
2 x
/
☞
Each CTCSS code complies to a specific tone frequency transmitted
by the walkie-talkie. Communication between the subscribers is only then
possible when both parties are using the same channel and CTCSS code.
An exception is CTCSS code "0". In the case of this setting, all the calls on
the set channel can be heard regardless of the CTCSS code. To be able to
participate in the radio communication, it may be necessary to switch from
CTCSS code "0" to the CTCSS code being used.
If you want to communicate with the walkie-talkies which are not
using a CTCSS, you must select CTCSS code "0" on your walkie-talkie.
8
Service-Hotline Germany: Tel. 0180 5 001388 (Costs for call from german
landline at time of print: 14 ct/min, max. 42 ct/min from mobile phone providers.)
Press the menu key.
Press ▲ or ▼ to select the desired channel.
446.00625
446.01875
446.03125
446.04375
Press the menu key twice.
Select the CTCSS code and confirm with the PTT but-
ton.
Channel Frequency (MHz)
5 446.05625
6 446.06875
7 446.08125
8 446.09375