Product Description And Specifications; Intended Use; Product Features - Bosch GAM 270 MFL Professional Originalbetriebsanleitung

Do not use the laser goggles as protective goggles. The laser goggles
u
make the laser beam easier to see; they do not protect you against laser
radiation.
Do not use the laser goggles as sunglasses or while driving. The laser
u
goggles do not provide full UV protection and impair your ability to see
colours.
Have the measuring tool serviced only by a qualified specialist using
u
only original replacement parts. This will ensure that the safety of the
measuring tool is maintained.
Do not let children use the laser measuring tool unsupervised. They
u
could accidentally dazzle someone.
Do not use the measuring tool in explosive atmospheres which con-
u
tain flammable liquids, gases or dust. Sparks may be produced inside
the measuring tool, which can ignite dust or fumes.
When sawing workpieces for which you have determined the angle
u
using this measuring tool, always strictly follow the safety instruc-
tions and working advice for the saws in use (including instructions
on positioning and clamping the workpiece). When the required angles
cannot be set on a certain saw or saw type, alternative sawing methods
will need to be applied. Extremely acute (sharp) angles can be cut using a
taper jig with a table saw or a circular saw.

Product Description and Specifications

Please observe the illustrations at the beginning of this operating manual.

Intended Use

The measuring tool is intended for measuring and transferring grades and
angles, calculating simple and compound mitre angles, and checking and
aligning horizontals and verticals.
The measuring tool is suitable for indoor and outdoor use.

Product Features

The numbering of the product features shown refers to the illustration of the
measuring tool on the graphic page.
(1) Fold-out leg
(2) Viewing window for display
(3) Locking wheel
(4) Base leg
(5) Battery compartment cover
(6) Battery compartment cover locking mechanism
(7) Display for angle measurement
(8) Display for grade measurement
(9) Level for horizontal alignment
(10) Level for vertical alignment
(11) Laser beam outlet aperture
(12) Laser warning label
(13) Serial number
(14) On/off button
(15) Button MTR1 for simple mitre
(16) Button MTR2 for compound mitre
(17) Button Hold
(18) On/off button for laser
(19) Audio signal button
(20) Calibration button/unit of measurement change
(21) Leg extension
(22) Protective bag
Display Elements
(a) Indicator H for saved value Hold
(b) Battery indicator
(c) Bevel angle indicator BVL
(d) Horizontal mitre angle indicator MTR
(e) Corner angle indicator CNR
(f) Slope angle indicator SPR
(g) Measured value for angle measurement
(h) Upwards alignment aid
(i) Downwards alignment aid
(j) Laser operation indicator
(k) Unit of measure mm/m
(m) Unit of measure °; %
(n) Grade measurement value
(o) Indicator for audio signal
Bosch Power Tools
English | 17
1 609 92A 58L | (22.11.2019)