Product Description And Specifications; Intended Use; Product Features; Technical Data - Bosch GAM 270 MFL Professional Originalbetriebsanleitung

OBJ_BUCH-2370-004.book Page 17 Wednesday, January 11, 2017 3:01 PM
 When using the angle information provided by this tool to cut work-
pieces, always strictly observe the safety and working instructions of
the saw being used, including those for positioning and clamping the
workpiece. When the required angles can not be set on a certain saw or
saw type, alternative sawing methods will need to be applied. Extremely
acute (sharp) angles can be cut using a taper jig with a table saw or a cir-
cular saw.

Product Description and Specifications

Please unfold the fold-out page with the representation of the measuring tool
and leave it unfolded while reading the operating instructions.

Intended Use

The measuring tool is intended for measuring and transferring grades and
angles, calculating simple and compound mitre angles, and checking and
aligning horizontals and verticals. It is suitable for indoor and outdoor use.

Product Features

The numbering of the product features shown refers to the illustration of the
measuring tool on the graphic page.
1 Fold-out leg
2 Viewing window for display
3 Locking wheel
4 Base leg
5 Battery lid
6 Latch of battery lid
7 DisplayAngle measuring device
8 DisplayGrade measuring device
9 Spirit level for horizontal alignment
10 Spirit level for vertical alignment
11 Laser beam outlet opening
12 Laser warning label
13 Serial number
14 "ON/OFF" button
15 "MTR1" button for simple mitre
16 "MTR2" button for compound mitre
17 "HOLD" button
18 On/Off button for laser beam
19 Audio signal button
20 Calibration/change units button
21 Leg extension
22 Protective pouch
Display Elements
a "H" indicator for "HOLD" memory value
b Battery indicator
c Bevel angle indicator "BVL"
d Mitre angle indicator "MTR"
e Corner angle indicator "CNR"
f Spring angle indicator "SPR"
g ReadingAngle measuring device
h/i Alignment aids
j Laser operation indicator
k/m Unit of measure indicator
n Measuring valueGradient Measurement
o Indicator for audio signal

Technical Data

Digital angle and grade measuring device
Article number
"HOLD" function
"Simple Mitre" Operating Mode
"Compound Mitre" Operating Mode
"Grade Measurement" Operating mode
Display Illumination
Calibration
Measuring range of angle measuring device
Angle measuring accuracy
Lowest indication unit
Operating temperature
Storage temperature
1) Operating duration without laser
2) The working range can be decreased by unfavourable environmental conditions
(e.g. direct sun irradiation).
The measuring tool can be clearly identified with the serial number 13 on the type plate.
Bosch Power Tools
English | 17
GAM 270 MFL
3 601 K76 400






0°...270°
±0.1°
0.1°
–10 °C...+50 °C
–20 °C...+70 °C
1 609 92A 3SG | (11.1.17)