Klarstein 10034270 Bedienungsanleitung Seite 15

Mounting the feet
Note: Before assembling, make sure that the unit is disconnected from the power
supply. Never install, move or clean the heater while it is connected.
1. Turn the heater (A) carefully upside down and lay it on a clean, soft surface.
2. Place the foot (B) on the corner of the chimney frame.
3. Fasten the base with two screws (C). Tighten the screws only slightly for the time
being.
4. Repeat steps 2 and 3 for the other three feet.
5. Check the alignment of the feet and then tighten all 8 screws with the screwdriver,
but not too tight.
Note: Fasten the feet before first use! Never connect this unit if the feet are not
securely attached.
EN
15