Installation; Points To Be Considered When Re-Transporting Your Refrigerator; Before Operating Your Refrigerator; Electric Connection - Beko DNE 65020 X Bedienungsanleitung

3

Installation

B
Please remember that the manufacturer
shall not be held liable if the information
given in the instruction manual is not
observed.
Points to be considered
when re-transporting your
refrigerator
1.
Your refrigerator must be emptied and
cleaned prior to any transportation.
2.
Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
3.
Packaging must be tied with thick tapes
and strong ropes and the rules of
transportation printed on the package
must be followed.
Please do not forget...
Every recycled material is an indispensable
source for the nature and for our
national resources.
If you wish to contribute to recycling the
packaging materials, you can get further
information from the environmental
bodies or local authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1.
Is the interior of the refrigerator dry and
can the air circulate freely in the rear of
it?
2.
Please install the 2 plastic wedges as
illustrated in the figure. Plastic wedges
will provide the required distance
between your refrigerator and the wall
in order to allow the air circulation. (The
illustrated figure is only an example
and does not match exactly with your
product.)
3.
Clean the interior of the refrigerator as
recommended in the "Maintenance and
cleaning" section.
4.
You will hear a noise as the compressor
starts up. The liquid and gases sealed
within the refrigeration system may
also give rise to noise, even if the
compressor is not running and this is
quite normal.
5.
Front edges of the refrigerator may feel
warm. This is normal. These areas
are designed to be warm to avoid
condensation

Electric connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
• The connection must be in compliance
with national regulations.
• The power cable plug must be easily
accessible after installation.
• The specified voltage must be equal to
your mains voltage.
8
EN