Inhaltsverzeichnis
Werbung
Welcome to use our half-electric stacker SPM series. Your
stacker is made of high quality steel and SPED mast and was
designed to give a durable, reliable and easy to use product.
For your safety and correct operation, please carefully read this
instruction book and warnings on the stacker before using it.
NOTE!
All of the information reported herein is based on data
available at the moment of printing. We reserves the right to
modify our own products at any moment without notice and
incurring in any sanction. So, it is suggested to always verify
possible updates.
1. STRUCTURAL DATA FORM
Model
Capacity
Kg
Lift Height
mm
Fork Size
mm
Single Fork Size
mm
Overall Height
mm
Lift Speed with/without Load
mm/sec
Lower Speed with/without
mm/sec
Load
Min. Fork Height
mm
Battery
Motor of Hydraulic Pump
2. SAFETY GUIDANCE
2.1 Operator should read all warning signs and instructions here and on the
stacker before using it.
2.2 Do not operate a stacker unless you are familiar with it and have been
trained or authorized to do so.
2.3 Do not operate a stacker unless you have checked its condition. Give
special attention to the chain, the wheels, the handle, the guide frame, the
pilot wheel, the mast, battery, etc.
2.4 Do not use on a slopping ground or on a barbaric or explosive
danger environment.
2.5 Do not take up any people on the forks.
2.6 When forks lifting, forbid anyone to stand under the forks or pass through
the forks.
2.7 The operator had better take on gloves for labor protecting.
2.8 Do not move the stacker when the goods are lifted to the height
more than 300 mm.
2.9 When the goods have been transported or lifted, all people should be
away from the forks for 600mm.
2.10 The weight of goods should be distributed on the two forks, do not use only one
fork. The center of gravity of goods should be in the center of two forks.
Do not load over maximum capacity.
2.11
Before using or charging it, check cell liquid, if not enough, full it with
2.12
distilled water.
2.13 Charging should be in dry and ventilated location, and far away from the fire.
Keeping the forks in the lowest position if not using.
2.14
2.15
At other special condition or place, the operator should be carefully to
operate the stacker.
3. MAINTENANCE
3.1 Hydraulic oil
Please check the oil level every six months. The oil can be hydraulic oil: ISO
VG32, its viscosity should be 32cSt at 40oC, total volume is about 4.0lt.
3.2 Daily check and maintenance
It is necessary to check the stacker daily. Special attention should be paid to
the wheels, the axles, as thread, rags, etc., it may block the wheels, the fork and
the mast, the chain, the battery should be checked, too. The forks should be
unloaded and lowered in the lowest position when the job is over.
3.3 Lubrication
Use motor oil or grease to lubricate all movable parts.
4. HOW TO CHARGE STORAGE BATTERY
4.1 Charge storage battery when its voltage is less than 10 Volt.
4.2 The charging environment should be ventilated and far away from the fire.
4.3 If the stacker not use for long time, charge it for not less than two hours
4.4 The voltage on the indicator should not be over 15 Volt when charging.
4.5 Do not use the stacker when charging.
5. CONTROL PANEL
SPM10
1000
Key switch
1600/2500/3000
570x1100(1150)
Charger socket
1100(1150)x180x60
5.1 Urgent switch
1980/1830/2080
When you press down this switch, it will switch off the power, and then you turn it
80/130
clockwise, it will switch on the power.
0~420/0~190
5.2 Voltage meter
It indicates the voltage of battery. When its voltage is less than 10 Volt, you
85
should not use this stacker, you must charge it.
DC12V, 150AH
5.3 Control stick
DC12V, 1.5KW
This stick controls the forks to lower or lift.
5.4 Charger socket
Use standard AC outlet to charge the battery.
6. TROUBLES SHOOTING
Trouble
The forks can not be up
the max. height.
The forks can not be lif-
ted up.(Motor is rotary)
The motor cannot run.
-The urgent switch is
pressed down, cut off
the power.
-The voltage is too lower.
-The connectors of elec-
trical wire is loose.
-The contactor of DC
motor is bad.
The forks cannot be
descended.
Leaks
The fork descends wit-
hout the release valve
worked.
Battery cannot be
charged
NOTE: Do not attemp to repair the stacker unless you are trained and authorized
to do so.
2 | 01-2811700 • ajproducts.ie
every week.
Urgent button
Battery indicator
Key
Clause
-The hydraulic oil is not
enough.
-Without hydraulic oil.
-The oil has impurities.
The motor cannot run.
-The urgent switch is
pressed down, cut off
the power.
-The piston rod or mast
is deformed resulting
from partial loading
slanting to one side or
over-loading.
-The fork was kept in
the high position for
long time with piston rod
bared to arise in rusting
and jamming of the rod.
-The release valve of
pump is not opened.
-Sealing parts worn or
damaged.
-Some part cracked or
worn into small.
-The impurities in the oil
cause the release valve to
be unable to close tight.
-Sealing parts worn or
damaged.
-The release valve is
damaged.
-Battery is bad.
-The charging plug is
loose.
Charger indicator
Control stick
Fixing Methods
-Pour in the oil.
-Fill in the oil.
-Change the oil.
-Turn it clockwise, switch
on the power
-Charge it.
-Turn it firm.
-Replace with new one.
- Replace with new one.
-Keeping the fork in the
lowest position if not
using, and pay more
attention to lubricate
the rod.
-Check it, if damaged,
replace with new one.
-Replace with the new
one.
-Replace with the new
one.
-Replace with new oil.
-Replace with the new
one.
-Replace with the new
one.
-Turn it firm.
Werbung
Inhaltsverzeichnis
