Replacing The Lamp; Installation - Electrolux EN3614AOX Benutzerhandbuch

34 www.electrolux.com

7.1 Replacing the lamp

1
7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
2
The appliance is equipped with a longlife
LED interior light.
1. Disconnect the appliance.
2.
Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. If needed replace the lamp with a light
of similar characteristic and power. It is
suggested to use Osram PARATHOM
SPECIAL T26 0.8 Watts.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the
lamp comes on.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
Cli- Ambient temperature
mate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C