Electrolux ERF3310AOW Benutzerhandbuch Seite 30

30 www.electrolux.com
Problem
"dEMo" appears on
the display.
The compressor
runs continuously.
Water flows inside
the refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
cold.
The temperature in
the appliance is too
warm.
The temperature in
the refrigerator is
too warm.
Possible cause
The appliance is in dem-
onstration mode.
The Temperature regulator
may be set incorrectly.
The door is not closed
correctly.
The door has been
opened too frequently.
The food temperature is
too high.
The room temperature is
too high.
The water outlet is clog-
ged.
Food prevent that water
flows into the water collec-
tor.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The Temperature regulator
may be set incorrectly.
The Temperature regulator
may be set incorrectly.
The door is not closed
correctly.
The food temperature is
too high.
There is no cold air circu-
lation in the appliance.
Large quantities of food to
be cooled were put in at
the same time.
Solution
Keep pressed approximate-
ly 10 sec the OK button
since a long sound of buz-
zer is heard and the display
shut off for a short while:
appliance start works regu-
larly.
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the food temperature
decrease to room tempera-
ture before storage.
Decrease the room temper-
ature.
Clean the water outlet.
Make sure that food do not
touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a warmer temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the food temperature
decrease to room tempera-
ture before storage.
Make sure that there is cold
air circulation in the appli-
ance.
Insert smaller quantities of
food to be cooled at the
same time.