Connecting The Appliance; Switching On The Appliance - DeDietrich KISDDW00FF Bedienungsanleitung

Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with
a 10 A fuse or higher.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may
be replaced by an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or
to power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
Switching on the
appliance
Fig. 2
The appliance is switched on and off
with button 1.
Warning signal sounds, the freezer
compartment temperature has still
not been reached.
Press button 2, warning signal stops.
The warmest temperature in the freezer
compartment is displayed for five seconds
and is then cleared.
Then the set refrigerator compartment
temperature is displayed.
When the display is to show the
temperature in the freezer compartment,
press button 4 freezer". AL" then
appears on the display until the
temperature set for the freezer
compartment is reached.
The factory has recommended and set
the following temperatures:
Refrigerator compartment +4 °C
Freezer compartment -18 °C
Notes:
Fig. 3
It is quite normal for condensation or
hoarfrost to form on the inside of the rear
panel. The hoarfrost thaws automatically
and runs into the evaporation pan via the
condensation channel.
Keep the condensation channel and
outlet clean, as the condensation must be
able to drain away.
en
27