Grid Preparation; Building In The Appliance Under A Worktop - DeDietrich drf 313 je Handbuch

Grid preparation

Left door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure).
A
DO002/2
Right door opening:
Remove the right side (B) of the grid cutting it from
the rear (see figure).

Building in the appliance under a worktop

Dimensions of the recess
The dimensions of the recessed installation area
must correspond with those indicated in the figure.
DO013
Installation kit
1xB
1xA
2
2
1
22
B
2xC
12
1
2
1
To position the grid on the appliance proceed as
follows:
Apply the grid to the base of the appliance by
pushing on to the clasps (a) until they click.
a
DO001
1. Two cabinet securing brackets are supplied with
the installation pack. They need to be assembled
onto the cabinet prior to cabinet being pushed into
the Kitchen aperture.
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
- Position the two brackets as shown in the figure
and replace the two securing screws.
Left hand
bracket
a
Right hand
bracket