Motorola PMLN7093 Bedienungsanleitung Seite 7

LED Charger State
Indication
Error
•
Red Fast
Flash
•
•
•
•
Charging
Steady Red
Fully Charged
Steady
Green
Standby
Flashing
Yellow
If there is NO LED indication:
1. Check if the radio with battery, or the battery alone, is inserted correctly (refer to
step 3 on page 6).
2. Make sure the power cord is securely plugged into the charger and an appropriate
AC outlet and that there is power to the outlet.
3. Confirm that the battery used with the radio is listed in Table 2.
Table 4: Charger LED Indicator (Continued)
The Charger identified the
Battery as invalid or damaged
The Charger may have
detected an open or shorted
Battery contact
Excessive Power Supply
Voltage
Battery Under-Voltage
Recovery Timeout (15
minutes)
Charging Issue
Comment
Remove the battery from the
pocket. Inspect the charger and
battery contacts to ensure they are
clean. Reinsert the battery.
If the indication continues,
disconnect the power cord from the
bottom of the charger and inspect
the power cord and charger
connectors to ensure they are
clean and ready for use.
Connect an authentic Motorola
Solutions power cord to the
charger.
If the indication continues,
try using a different Motorola
Solutions authorized battery.
If the indication continues with a
different battery, contact your
Motorola Solutions representative.
The battery is charging.
The battery may be used.
The charger is on standby mode.
5