Salter Aquatronic Gebrauchsanleitung Seite 2

INSERT 3 AAA BATTERIES
AAA
AAA
AAA
Ensure +/- terminals are the correct way round.
FITTING THE HANGING BRACKET TO THE WALL
This scale has a hanging hook which allows it to be hung on most standard utensil hanging rails.
Alternatively, it can be hung from its' own hanging bracket, which can be fixed to most walls.
When the scale is placed in a hanging position, the display automatically switches to a clock.
CAUTION: DO NOT hang the scale over a direct heat source, such as a cooker hob.
If possible, site at least 1m (3ft) distant from electrical products (such as a microwave oven) that
may emit electrical interference, which could disrupt the products display. If in doubt, test the
product in position, before drilling the wall to fix the bracket.
To fix the hanging bracket to a wall:
1. Observing the above caution please, choose
a position for the bracket that allows plenty
of room for the scale to hang unobstructed
and enables you to remove and replace the
scale easily.
2. With the bracket held in position against the
wall, mark the position of the round hole.
3. Select a suitable wall plug and drill a hole of
the correct size and depth to suit.
4. Fit the wall plug, and then screw the bracket to the wall, loosely. Holding the bracket horizontal,
mark the 2nd hole position. Move the bracket to one side and drill the second hole.
5. Fit the wall plug and then screw the bracket firmly to the wall, ensuring it remains level.
NOTE: The wall plugs supplied with this product are suitable for on solid walls and require a 5mm
diameter hole. For hollow or other wall types – use a suitable alternative fixing.
TO PRE-SET METRIC OR IMPERIAL UNITS
Every time the scale is switched on it will always
initially show either metric (g) or imperial (lb/oz)
units, according to the position of the slide
switch on the underside of the scale. Set this
switch to the units you generally prefer to use.
3