Settings Of Operation Values - Alutech Levigato LG Serie Montage- Und Betriebsanleitung

ADjUSTMENT
Y
ATTENTION! Before the first programming of the remotes, clean the drive memory from
the previously recorded remotes. If the remote control is absent, the number of the absent
remote control must be deleted from the memory to prevent the unauthorized entry. If the
number of the absent remote control is unknown, delete all numbers of the remotes and re-
record all remote controls.
6.3

SETTINGS Of OPERATION VALUES

The table 15 shows an example to enter the settings menu and to set the operation values.
Press and hold the button
1
programming mode
After the appearance of 'P1' inscription press the button
2
and select the required menu 'P№'
After the appearance of the required menu inscription press the
3
button
4 With the button
After the appearance of the required setting inscription press the
5
button
The value of setting will be on a display. The value will be with a dot. With the
6
button
After the appearance of the required value of setting press the button
7
The value will be with a dot, that means the change the setting
To exit the programming mode press the button
8
for 15 seconds (until automatic exit the setup menu)
The table 16 describes the settings, values of setting and default values for the drive supply.
MENU SETTING
P1 f4
P3 f1
LEVIGATO DRIVES (LG SERIES)
or
or select the required value of setting
DESCRIPTION
The adjustment of end positions. The function is
designed to monitor and adjust the end positions
once every 100 cycles of raising and lowering the
gate (fig. 16)
Automatic mode. The control is performed by
means of short presses on the control button
| LEVIGATO ANTRIEBE (SERIE LG)
for about 5 secs to enter the
select the required setting 'f№'
three times or wait
| COMMANDES LEVIGATO (SERIE LG)
or
.
VALUES
no—Off /on—ON
Table 15
Table 16
DEfAULT
VALUE
no.
on.
27