Adjustment Of The Door Position - Alutech Levigato LG Serie Montage- Und Betriebsanleitung

ADjUSTMENT
6.1

ADjUSTMENT Of THE DOOR POSITION

The end OPEN and CLOSED positions are set manually (setting P1–f1) or automatically (Ex-
press setup P1–f3 with a switch to the recording of remote controls). If the end positions are
not set, the drive does not execute a commands, and two dots will appear on the display
Y
After the end positions are set, P5 and P6 menu settings are automatically reset to the factory
default values (table 16).
SETTING P1–f1: programming the end positions manually
Press and hold the button
1
programming mode
2 After the appearance of 'P1' inscription press the button
After the appearance of 'f1' inscription press the button
3
Using the button
4
ATTENTION! In the OPEN position the carriage rail should be at a distance
20 mm from the support; installation of support is compulsory (fig. 16)
Press the button
5
means the OPEN position
Using the button
ATTENTION! Avoid excessive pressing of the door leaf against the doorway in
6 the CLOSED position. After programming the end positions, the force required
for the manual release (section 4.2. 'Manual release') must not be more then
220 Н
Press the button
means the CLOSED position.
7
ATTENTION! Automatic movement of the door begins immediately
The door automatically moves to the OPEN position
8
The door automatically moves to the point of contact
9
The door automatically returns to the OPEN position
10
The door automatically returns to the CLOSED position
11
After completion of all positional settings of the door, 'f1' inscription will
appear; to exit the setup menu press twice the button
12
15 seconds
LEVIGATO DRIVES (LG SERIES)
or
; after that a dot will appear on the display, which
or
; after that a dot will appear on the display, which
| LEVIGATO ANTRIEBE (SERIE LG)
for about 5 secs to enter the
set the door in the OPEN position.
set the door in the CLOSED position.
| COMMANDES LEVIGATO (SERIE LG)
or wait for
.
Table 6
21