Radio Control Setup - Alutech Levigato LG Serie Montage- Und Betriebsanleitung

ADjUSTMENT
The PEDESTRIAN position can only be set when the end positions are set.
Press and hold the button
1
programming mode
2 After the appearance of 'P1' inscription press the button
3 After the appearance of 'f1' inscription press the button
4 After the appearance of 'f2' inscription press the button
After the appearance of 'PE' inscription set the door in the PEDESTRIAN position
5
with the buttons
Press the button
6
means the pedestrian position
7
To exit the menu, press twice the button
6.2

RADIO CONTROL SETUP

The menu 'P2' (tab. 9) offers six settings of the remote control recording (f1–f6), the setting of
defining the recording number of the remote control (f7), two settings of deleting the remote
control (f8, f9) and the setting of deleting all remote controls (f0).
MENU SETTING
f1
f2
f3
f4
f5
f6
P2
f7
f8
f9
f0
LEVIGATO DRIVES (LG SERIES)
or
; after that a dot will appear on the display, which
Recording of one button with 'SBS' control mode
Recording of two buttons with 'SBS' and 'PE' control modes
Recording of two buttons with 'SBS' and 'LL' control modes
Recording of three buttons with 'SBS' and 'LL' control modes
Recording of four buttons with 'OP', 'STOP', 'CL' and 'PE' control modes
Recording of four buttons with 'OP', 'STOP', 'CL' and 'LL' control modes
Determining the recording number of the remote control in the memory
(if there is a remote control)
Deleting the remote control based on its code (it is used when there is a remote
control but the information for the remote control number in the drive memory is
not available)
Deleting the remote control based on the number in the drive memory (it is used
when a remote control is absent but the information for the remote control number
in the drive memory is available)
Deleting all remote controls
| LEVIGATO ANTRIEBE (SERIE LG)
for about 5 secs to enter the
or wait for 15 seconds
DESCRIPTION
| COMMANDES LEVIGATO (SERIE LG)
Table 8
Table 9
23