Chicco Easy Touch Gebrauchsanleitung Seite 16

Press the "Measure" button, and gen-
tly scan around the temple area( Fig.5
) , you can select the left side of the
left temples or the right side of the
right temples. Measurement has been
completed after a long beep is heard.
(The time of measurement might be
between 5~8sec (up to 30sec). That
depends on when the thermometer
get the highest temperature of the
forehead.)
Note: the temperature can be differ-
ent between right and left temple: it
depends on the fact that the deepness
and the dimension of the temporal
artery can be different in left and
right part.
The thermometer can work in SCAN
Mode too. To select the SCAN mode:
While the unit is ON, hold down the
"ON/MEM" button, and press the
"Measure" button, then the
will replace "HEAD" icon in the LCD
display (see figure 6)
Measuring temperature under SCAN
mode: When you press the "Measure"
button, you will get the temperature
immediately about 0.6 sec. If you
hold down the scan button, the read-
ing of measurement will be continu-
ous updated. (This mode shows the
actual, unadjusted temperatures of
the objects, which is different with the
forehead mode.)
IMPORTANT
To constantly obtain accurate results,
always direct the thermometer to the
same area of the forehead every time
you measure temperature. To take
repeated measurements, always scan
the same area of the forehead. Wait
for at least 2 minutes between con-
secutive measurements to avoid
the overheating of the sensor, which
may detect non-consistent values.
too long and/or expose the device to
external heating source may cause a
higher ambient temperature reading
of the sensor. This could make the
body temperature / object tempera-
ture measurement lower than usual.
MEMORY FUNCTION
icon While the thermometer is On, press
the "ON/MEM" button to see the
temperature stored. This thermom-
eter provides 25 sets memory for
the last measurements. ** Please be
Figure 6 noted that only the "HEAD" func-
tion's reading will be recorded. (When
the thermometer is turned off, the
last measurement data is saved into
memory.)
CELSIUS (°C) / FAHRENHEIT (°F)
DEGREES SELECTOR
To change the LCD from °C to °F:
When the unit is OFF, hold down the
"Measure" button, then press and
hold the "ON/MEM" button until
16
Holding the thermometer