Charging Mobile Phones And Tablets; Using The 12 Vdc Output 8 A With The Cigarette Lighter Adapter; Switch On Lighting - ULTIMATE SPEED UMAP 12000 A1 Bedienungs- Und Sicherheitshinweise

1
As soon as the vehicle starts,
remove the jumper cable
portable jump starter with power bank
within 30 seconds and firstly disconnect
the black battery clamp and then the red
battery clamp from the battery poles.
Otherwise, it could result in dangerous
situations!
Leave the vehicle engine running.
„ „
Note: The button on the LED box
the jumper cable has no effect and must
not be used. It is only used for trouble-
shooting purposes during the manufac-
ture of the device.
z Charging mobile phones
and tablets
Press the power button
„ „
Connect your mobile phone or tablet's
„ „
USB power cable to the USB output
(5 V /1 A /2 A
5
your mobile phone or tablet.
Note: Charging is not possible if the
portable jump starter with power bank
is already fully charged.
z Using the 12 VDC output
8 A with the cigarette
lighter adapter
Press the power button
„ „
Connect the 12 V / 8 A cigarette lighter
„ „
adapter to the 12 VDC output 8 A
14
B A
2. 1.
from the
10
of
11
7
.
) and then to
6
7
.
3
of your portable jump starter with power
bank and then to your end device.
Note: Usage is not possible if the portable
jump starter with power bank is already fully
charged.
Attention: Only use the supplied
12 V / 8 A cigarette lighter adapter. There is
a risk of short-circuiting if external adapters
are used.
z Switch on lighting
Light mode
When switching on the LED light
„ „
down the power button
Press and hold the power button
„ „
another 3 seconds to turn the LED light
2 off again.
Flash mode
To switch on the LED light
„ „
or SOS mode, first press the power
button 7 for 3 seconds. Then the LED
light 2 will be permanently lit.
Briefly press the power button
„ „
again and the LED light will switch to
flash mode.
Briefly press the power button
„ „
again and the LED light
to SOS mode. There will be 3 short
flashes, 3 long flashes and another
3 short flashes.
Briefly press the power button
„ „
again to switch off the LED light
CAUTION! Do not look directly at the
LED lights 2 as this can damage your
eyes.
Please note: It is not possible to turn
on the light while the portable jump
starter with power bank is charging.
Using the device
2 , hold
7 for 3 seconds.
7 for
2
in the flash
7 once
7 once
2 will switch
7 once
2
.
GB/MT 55