Using The Jumpstart Feature - ULTIMATE SPEED UMAP 12000 A1 Bedienungs- Und Sicherheitshinweise

Using the device
Note: An undervoltage protection circuit
is installed in the portable jump starter with
power bank to protect the device from
1
damages. This prevents a deep discharge of
the portable jump starter with power bank
and automatically switches the device off
1
once the battery is fully discharged. Shortly
before the undervoltage protection circuit
becomes active, the last blue indicator light
starts flashing. As soon as the under-
8
voltage protection circuit is active, the last
Step
1. Connect the jumper
cable 10 of the
portable jump starter
with power bank to
the vehicle jumpstart
outlet of the
9
portable jump starter
with power bank
2. First connect the red
battery clamp (A) to
the positive pole of the
vehicle battery and
then connect the black
battery clamp B to
the negative pole
(see picture 1).
3. Starting up the
vehicle.
54 GB/MT
LEDs
13
Red Error LED
continuously lit on the jump-
10
er cable .
Green Start LED
1 .
the red Error LED
alternately.
The red Error LED
flashes, a short alarm signal
sounds.
The red Error LED
flashes, a continuous alarm
signal sounds.
The red Error LED
once, a continuous alarm is
sounded and then followed
by two short alarm sounds.
Green Start LED
the red Error LED
alternately. After 1–2
seconds only the green LED
12
glows.
blue indicator light
energy can be obtained. Please re-charge
the portable jump starter with power bank
.
1
z Using the jumpstart feature
When using the jumpstart, make sure
„ „
that at least 3 indicator lights
permanently illuminated.
Meaning / Error
The voltage
is
determined in the
portable jump starter
with power bank is
not enough to start
the car.
Portable jump starter
12
and
with power bank
flash
13
ready for operation.
The temperature is
13
too high, possibly
due to several jump
start attempts.
Battery clamps (A)
13
and (B) are the
wrong way round.
It is caused by a short
circuit or the battery
13
flashes
is leaking.
The connection is
12
and
correct
13 flash
flashes and no more
8
are
8
Solution
Charge the
portable jump
starter with
power bank.
Carry on with
step 2.
First discon-
nect the black
battery clamp
(B) and then
the red clamp
(A) from the
battery poles.
Start again
with step 1.
Carry on with
step 3.