Product Description - GYS ORBITIG 200 A Bedienungsanleitung

MADE IN FRANCE
INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorized by the manufacturer should perform the installation of the welding equipment.
During the installation, the operator must ensure that the machine is disconnected from the mains. Connecting gene-
rators in serial or in parallel is forbidden.

PRODUCT DESCRIPTION

This welding machine is an inverter welding unit designed for use on refractory electrodes (TIG) in direct current (DC).
Totally driven by a robot, the communication is made through a CAN BUS and a protocol CAN OPEN.
The welding machine follows and regulates the current instruction in realtime. This mode is called « TRACKING ».
POWER SUPPLY - POWER UP
The Orbitig 200A is supplied without a plug and features the «Flexible voltage» technology and as such needs to be
connected to an electrical earthed installation supplying power between 110V and 240V (50-60 Hz).
The absorbed effective current (I1eff) is displayed on the machine, for optimal use. Check that the power supply used and
its protection (fuse and/or circuit breaker) are compatible with the current required by the machine. The user has to make
sure that the plug can be reached.
The device switches to protection mode if the power supply voltage is below or above the required voltage by 15% (the
screen displays an error code).
USE ON EXTENSION LEADS
All extension leads must have appropriate size and thickness for the machine voltage.
Use an extension that complies with national safety regulations.
200A source
TUNGSTEN ELECTRODE WELDING WITH INERT GAS (TIG MODE)
CONNECTIONS AND RECOMMENDATIONS
Connect the earth clamp to the positive connector (+).
Connect the torch earth cable to the negative plug (–).
Ensure that the torch is equipped and ready to weld, and that the consumables (Vise grip, ceramic gas nozzle, collet and
collet body) are not damaged.
TIG WELDING PROCESSES
• TIG DC
This welding mode in direct current (DC) is designed for ferrous metal such as steel, stainless steel or even copper and its
alloys.
• TIG DC Pulsed
This pulse welding mode chains high current pulses (I, welding pulse) then low current pulses (I_cold, pulses to cool the
piece). This pulse mode allows to assemble pieces while while keeping the machine cooler.
SELECT IGNITION MODE
The arc initiating and stabilizing device is designed for manual and mechanically guided operation.
HF TIG: High Frequency start without contact.
Warning: Increasing the length of the torch or earth return cables beyond the maximum length specified by the manu-
facturer will increase the risk of electric shock.
TIG LIFT : Contact start (for environments sensitive to HF disturbances).
12
ORBITIG 200 A
Current input Length and thickness of the extension lead
230V
110V
< 100m - 2.5 mm²
< 45m - 2.5 mm²
< 100m - 4 mm²
EN