Pelgrim GVW580ONY Benutzerinformation Seite 29

A A
B B
C C
1. To unlock the filter system, turn the
handle on the microfilter (B) approxi-
mately 1/4 counterclockwise.
2. Remove the filter system.
3. Hold the coarse filter (A) by the handle
with the hole.
4. Remove the coarse filter (A) from the
microfilter (B).
5. Remove the flat filter (C) from the bot-
tom of the appliance.
What to do if...
The appliance does not start or stops dur-
ing operation.
Malfunction
The appliance • The light of the pro-
does not fill with gramme in progress
water. flashes.
• The end-of-programme
indicator light flashes 1
time.
Fault code
The water tap is
blocked or is furred with
limescale.
The water pressure is
too low.
The water tap is closed.
6. Clean the filters below running water.
7. Put the flat filter (C) to its initial position.
Make sure that it assembles correctly
under the two guides (D).
8. Put the coarse filter (A) in the microfilter
(B) and push the filters together.
9. Put the filter system in position.
10. To lock the filter system, turn the han-
dle on the microfilter (B) clockwise until
it locks in position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
First try to find a solution to the problem (re-
fer to the chart). If not, contact the service
centre.
Possible cause
D
Possible solution
Clean the water tap.
Contact your local wa-
ter authority.
Open the water tap.
29