AEG HC652600EB Benutzerinformation Seite 39

• Seal the gap between the worktop and glass ceramic with silicone.
• Put some soapy water on the silicone.
• Pull off the excess silicone with the scraper.
The installation of more than one appliance
Added parts:connection bar(s), heat resist-
ant silicon, rubber shape, sealing strap.
+
580 mm
min.
38 mm
min.
2 mm
- =
360 mm 20 mm 920 mm
Only use special a heat - resistant
silicon.
The worktop cut out
Distance from the wall : minimum 50 mm
Depth : 490 mm
Width : sum widths of all the appliances to
be built-in and subtract 20 mm (see also
"Overview of all appliance widths" )
The installation of more than one appliance
1. Put down the dimension of the work-
top cut out and saw it out.
2. Put the appliances one at time on
some soft surface, a blanket for exam-
ple, with the bottom side up.
3. Put the seal stripe around the lower
edge of the appliance along the outer
edge of the glass ceramic.
4. Loosely screw the fixing plates into the
appropriate holes in the protective
casing.
5. Put the first appliance in the worktop
cut out. Put the connection bar in the
worktop cut out and push up half of
the width against the appliance.
39
Installation