Safety Notes; Installation Instructions; Symbol Description - HANSGROHE Marin Set 27561000 Gebrauchsanleitung, Montageanleitung



Safety Notes

Gloves should be worn during installation to prevent

crushing and cutting injuries.
Children as well as adults with physical, mental and/

or sensoric impairments must not use this shower
system without proper supervision. Persons under
the influence of alcohol or drugs are prohibited from
using this shower system.
The shower system may only be used for bathing,

hygienic and body cleansing purposes.
Do not allow the streams of the shower touch sensi-

tive body parts (such as your eyes). An adequate
distance must be kept between the shower and you.
The product may not be used as a holding handle. A

separate handle must be installed.
Shower hoses are only suitable for a connection

from the shower to the fitting. Never fit a shut-off
device between the fitting and the hose.
The hot and cold supplies must be of equal pres-

sures.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms!
• Optimal functioning is only guaranteed with the com-
bination of Hansgrohe hand showers and Hansgrohe
shower hoses.
• Where the contractor mounts the product, he should
ensure that the entire area of the wall to which the
mounting plate is to be fitted, is flat (no projecting
joints or tiles sticking out), that the structure of the wall
is suitable for the installation of the product and has
no weak points. The enclosed screws and dowels are
only suitable for concrete. For another wall construc-
tions the manufacturer's indications of the dowel
manufacturer have to be taken into account.
6
English
• The filter (94246000) must be insert to protect the
hand shower against incoming dirt by pipework.
Incoming dirt leads to defects or/and can damage
parts of the hand shower; such caused faults voids all
liability and guarantee claims. (see page 61)
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
anti-pollution function

Symbol description

Assembly see page 60
Do not use silicone containing acetic acid!
Dimensions (see page 64)
Flow diagram (see page 66)
Operation (see page 67)
Safety Function (see page 68)
The desired maximum temperature for exam-
ple max. 42º C can be pre-set thanks to the
safety function.
Adjustment (see page 69)
After the installation, the output tempera-
ture of the thermostat must be checked. A
correction is necessary if the temperature
measured at the output differs from the
temperature set on the thermostat.
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80 °C
65 °C