Installing NIBE CMO
11
Caution
The images show the inverter upside-down on
the floor prior to installation on the wall.
1.
Disconnect the power to the inverter
2.
Remove the cover as illustrated
NOTE
It is not possible to combine CMO 11 with
EME 20.
CMO 11 | GB
3.
Pull out the white cable and install it in the commu-
nication module. It may be hidden under the edge,
so carefully ease it out. It is connected at one end,
so pull it out carefully and connect it to CMO 11.
Screw the communication module into place,
4.
checking that the cable is properly located before
you screw it in place.
7