Placing The Product; Cleaning And Storage - Silvercrest SWGF 2400 B1 Bedienungs- Und Sicherheitshinweise

mCAUTION! The surfaces are
liable to get hot during use .
mBurn hazard! The product
surface is subject to residual
heat for some time after use .
Do not touch the product's
hot surfaces and beware of
escaping steam . Hold the
product by its handle only .
mBurn hazard! Do not open
the lid while the water is boiling .
The product's lid must remain
securely closed while the
product is in use .
If you notice any smoke or
unusual noises, immediately
disconnect the product from the
power supply . Have the product
checked by a specialist before
continued use .
mWARNING! Do not use
the product if the water kettle
shows cracks or other signs of
damages .

Placing the product

The product must not be placed
directly below a power supply .
10 GB
Always use the product on a
flat, stable, clean, heat-resistant
and dry surface .
Operation
The product shall only be used
with the supplied base .
Do not overfill the product . If
the product is overfilled, boiling
water may be ejected . Do not
operate the product without
water . The fill level of the
product must be between the
MIN and MAX marks on the
water gauge .

Cleaning and storage

The product shall not be
exposed to any dripping or
splashing water .
Disconnect the product from the
power supply before cleaning
and when not in use .
Refer to the "Cleaning and
care" section for instructions on
how to clean the product .
˜ Before first use
Remove all the packaging materials .
Clean the product (see "Cleaning and care") .
Boil the maximum water volume of 1 .7 litres
(see „Operation") . After boiling, discard the
water to remove any production and transport
residues .