Ingersoll-Rand 2131P Bedienungsanleitung Seite 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable
positions may be harmful to
your hands and arms. Stop
using any tool if discomfort,
tingling feeling or pain occurs.
Seek medical advice before re-
suming use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
USING THE POWER MANAGEMENT SYSTEM
Air wrenches are not torque control devices. Fasteners
with specific torque requirements must be checked
with suitable torque measuring devices after
installation with an air wrench.
MODEL 2131P AND 2131P7 POWER
MANAGEMENT SYSTEM
POWER SETTING INDICATORS
MINIMUM
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by the
hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620 kPa)
620 kPa) Maximum air pres-
sure.
MAXIMUM
POWER
MANAGEMENT
DIAL
(Dwg. TPD1339)
WARNING
WARNING
WARNING
Models 2131P and 2131P7 Impactools incorporate a
Power Management System that allows the operator to
select four power output settings. These settings range
from minimum power output through maximum power
output in the forward direction only. The Air Wrench will
always operate at maximum power output in the reverse
direction, no matter what power output level is selected.
The four power setting indicators of increasing size on
the rear of the housing indicate increasing power
output levels, are for reference only and DO NOT
denote a specific power output. The smallest power
setting indicator designates minimum power output,
the two middle power setting indicators denote medium
power outputs and the largest power setting indicator
denotes maximum power output.
The power output can be further reduced in forward
or reverse by using the variable throttle. Air supply
systems which do not deliver adequate air pressure can
affect power output at all settings.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before instal-
ling, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.