ZyXEL NBG-318S Schnellstartanleitung Seite 12

7 When you are finished setting up your powerline network, connect your powerline
adapters to the devices you want on your network, such as computers and a router for
connection to the Internet. See the figure on page
Troubleshooting
If the login screen does not display, follow these steps.
1 Check your computer's IP address settings or make sure your computer is set to
receive an IP address dynamically (see the appendix in the User's Guide).
2 If you cannot access the web configurator using Internet Explorer in Windows XP or
Windows Server 2003, check your web browser's security settings (see the appendix in
the User's Guide).
If you cannot access the Internet when your computer is connected to one
of the NBG-318S's LAN ports, follow these steps:
1 If an LED does not turn on, check your connections. Then turn the NBG-318S off, wait
for a few seconds and turn it back on.
2 Log into the web configurator again. Make sure you type in the information correctly.
For example, if your account has a user name and password, make sure you type it
correctly. In addition, if you are not sure which encapsulation your ISP uses, contact
your ISP.
3 Log in and go to Advanced setup. Go to Maintenance > Sys Op Mode. Select Router
(Ethernet WAN) if you connect to the Internet through your Ethernet port. Select
Router (HomePlug WAN) if you connect to the Internet through a HomePlug
connection.
4 If you are using a new Internet account, contact your ISP to make sure it is active.
5 If you still have problems, see Troubleshooting in the User's Guide.
If you cannot access the Internet from the wireless network, do the
following.
1 On a computer connected to the NBG-318S, make sure your NBG-318S and the
computers on your wireless network are using the same wireless and wireless security
settings. See the chapter on Wireless LAN in the User's Guide for more information.
ENGLISH
2 for an example.
12