ZyXEL NBG-318S Schnellstartanleitung Seite 11

4 Click Set to set the Network Name for all devices listed as Active in the My HomePlug
Network table below. These devices now have the Network Name you selected. With
the same Network Name they are now all on the same network.
5 Add a new device to your network by typing its MAC Address and DAK Password in
the Add New Member section. The DAK Password is found along with the MAC
Address on a label attached to the device. The DAK (Device Access Key) is a password
which gives you access to a powerline device, so you can change the device's Network
Name. Then type a Nickname such as "Mary's room" to help you identify the device.
Click Add. The device should appear as Active in the My HomePlug Network table
below.
• If MAC address error appears, check the MAC Address is correctly entered.
• If DEK format error appears, check the DAK Password is correctly entered.
6 Click Scan in the My HomePlug Network table to detect the other devices on your new
network.
• If a device is Active, it is connected to your network.
• If a device is Out of Network your NBG-318S has the details of this device but can-
not detect it. Check it is switched on and click Scan.
• If a device is Not Member or fails to appear in the table, try adding it in the Add New
Member section or by clicking on the Edit icon. See Troubleshooting for more sug-
gestions.
ENGLISH
11