Test Mode - OSRAM e:cue SYMPL relay Node Installationsanleitung

Test mode

6 Test mode
The SYMPL relay Node provides a Test mode for the connected loads.
There are two kinds: using the Identify button and using the web interface
of the SYMPL relay Node.
Please note that the Test mode overwrites all relay states from running
shows for the time of testing. A running show is reverted to after exiting the
Test mode.
The Test mode is indicated by the blinking Test / Error LED.
Test mode via Identify button
See section (C) on page 11 at "2.4 Identify button: Identification & Reset
& Testing".
Test mode via Web interface
The web interface of the SYMPL relay Node provides individual relay testing
in free combination.
To access the web interface, open a common web browser on a connected
PC. Enter the SYMPL relay Node's IP address into the address bar:
e.g. http://192.168.123.1.
Open the Test mode page by selecting "TestMode" on the left side of the
web interface of the SYMPL relay Node:
20