Ethernet Connection; Load Connection - OSRAM e:cue SYMPL relay Node Installationsanleitung

SYMPL Node on any flat vertical surface. Use a 3 to 3.5 mm screw for the
hanger hole.
For mechanical stability, mounting on a rail is recommended.
4.3

Ethernet connection

The pin-assignment of the Ethernet port corresponds to RJ45 standards.
You can use every common Ethernet component, like cable, splitters, and
switches. Connect the SYMPL relay Node at the designated Ethernet
interface with a patch cable (RJ45, CAT5).
Never connect more than one SYMPL Node in factory state
i
to a network. The identical IP addresses will conflict and
disturb proper communication.
The Ethernet port of the SYMPL Node is not designed for
i
inter-building connections with power and lighting transients.
Use only intra-building networks to connect the SYMPL
Nodes and Cores.
4.4

Load connection

The SYMPL relay Node can control three loads with its three relay
interfaces. Connect loads to the SYMPL Node using 3-pin terminal plugs at
the relay interfaces of the SYMPL Node.
1. Clip the device to the rail from
top.
2. Gentle pressure is then
applied to the top front to snap it
in place. The SYMPL relay Node
has been mounted successfully.
You can also mount the e:cue
Installation
15