Technical Data; Before Use - Hilti GTB 6X-A22 Bedienungsanleitung

Indication of the charge status is not possible while the power tool is in operation or immediately
after operation. If the battery charge status LEDs flash, please refer to the information given in the
Troubleshooting section.
4

Technical data

Weight in accordance with EPTA Procedure 01 including B22⁄8.0 battery
Rated voltage
Belt speed
Belt dimensions
Belt tension
Arc of contact
Maximum pipe diameter
Ambient temperature for operation
Storage temperature
4.1 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound power level (L
WA
Uncertainty for the sound power level (K
Vibration information
Triaxial vibration value (a
Uncertainty (K)
5

Before use

5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
*2241319*
)
pA
)
pA
)
)
WA
)
h
2241319
4.1 kg
21.6 V
3.8 m/s ... 8.4 m/s
760 mm x 40 mm
4 kg ... 9 kg
270°
125 mm
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
78 dB(A)
3 dB(A)
89 dB(A)
3 dB(A)
4.2 m/s²
1.5 m/s²
English 17