Air Filter; Spark Plug; Ordering Replacement Parts; Disposal And Recycling - EINHELL GE-PW 45 Originalbetriebsanleitung

•
After all the oil has drained, screw in the oil
drain plug and place the machine on a flat
surface.
•
Insert fresh engine oil up to the top mark on
the oil dipstick (Figure 5b / Item H). Important.
Only inset the oil dipstick to check the oil le-
vel. Do not screw it in.
While the machine is working, the oil level must
be between the two marks "L" and "H" (Figure 5b).
Dispose of the waste oil properly.
7.2.2 Air fi lter
Clean the air fi lter at regular intervals, and replace
it if necessary.
•
Remove the screw connection of the air filter
cover (Fig. 6a) and take off the air filter cover.
•
Remove the screw connection of the air filter
element (Fig. 6b) and take off the air filter ele-
ment.
•
Clean the air filter by tapping it or blowing it
with compressed air.
•
Assemble in reverse order.

7.2.3 Spark plug

Clean the spark plug at regular intervals, and
replace it if necessary. Set the electrode gap to
0.6 mm.
•
Remove the spark plug boot by twisting it (Fi-
gure 7)
•
Remove the spark plug using a spark plug
wrench
•
Clean the spark plug with a copper wire brush
or fit a new one.
•
Assemble in reverse order.
7.3 Storage
•
Rinse the pump thoroughly with water before
lengthy periods of inactivity or winter storage.
•
Close the petrol cock and allow the engine to
run until it stops to empty the carburetor.
•
Fill the tank fully to prevent rust formation.
•
Remove the drain plug (Figure 3 / Item 12)
and fully drain the pump housing.
•
Store the machine in a dry place out of the
reach of children.
GB

7.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
•
•
•
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
www.sidirika-nikolaidi.gr
- 19 -
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required