Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
–
–
–
Reminder
•
•
•
•
Hair styling. Example
Step one
Set the attachment comb (6) to the position
«5» or «8». Switch the hair clipper on with
the switch (3). Hold the unit with the blades
pointed upwards. Start cutting from the lower
part of the head. Slowly move the clipper
upwards. Cut all hair in the lower back area of
the head and near the ears (pic. 1, 2, 3).
Step two
Switch the hair clipper off with the switch (3) and
set the attachment to the position «11» or «14»,
switch the hair clipper on and continue cutting
hair closer to the top of the head (pic. 4).
Step 3: cutting in the temples area
Switch the hair clipper off, set the attachment
VT-2519.indd 6
hair clipper operates normally and the
blades move smoothly.
Switch the unit off, setting the switch (3)
to the position «OFF», take the power
adapter out of the mains socket. If there
is excess oil on the blades, remove it with
a dry cloth and then install the attachment
comb (6).
Seat a person so that his/her head is
approximately at your eye level, cover the
person's shoulders with a towel and set
hair with the comb (11).
Connect the power adapter (8) to the
mains socket and switch the unit on with
the switch (3).
Cut off a little amount of hair at a time; you
can always return to the cut part for addi-
tional cutting.
Set the hair with the comb (11) to reveal
uneven locks.
It is better to leave longer hair after cutting
for the first time.
After learning the unit better, you will be
able to arrange your hair in any style you
need.
to the position «5» or «8» and cut hair on the
temples. Then set it to the position «11» or
«14» and continue cutting towards the top of
the head.
Step 4: cutting the top of the head
Using the attachment comb in the position
«11» or «14», cut the hair from the top of the
head towards the crown against the hair
growth direction.
•
You can cut hair both against and along
the direction of hair growth, but keep
in mind that hair cut against the growth
direction will be shorter than the hair cut
along the growth.
•
For shorter haircut, set the attachment
comb (6) to the position «5» or «8».
•
To leave longer hair, grip hair locks
between your fingers and cut the hair off
using the clipper (pic. 5).
•
You can use the comb (11): lift the hair
locks and cut them off with the hair clip-
per over the comb (pic. 6).
•
Always start cutting from the head back.
•
Set the hair with the comb (11) to reveal
uneven locks.
•
Use the scissors to trim hair.
Step 5 - the final part
In the final stage of hair cutting, remove the
attachment comb (6) from the unit, turn the
blades of the hair clipper towards the hair and
carefully trim hair on the temples and neck
(pic. 7). Do not press the clipper strongly,
there is danger of injuries or cuts when open
blades come in contact with the skin.
Cone-shaped haircut
Set the necessary attachment comb and start
cutting from the head back towards the crown.
Cut hair against hair growth from the head
front to the crown and on the head sides (pic.
8). To get a flat top haircut, use the comb (11):
lift the locks and cut them along the comb. Set
the hair with the comb (11) to reveal uneven
locks.
6
03.10.2013 12:16:12
Werbung
