Vitek VT-2519 BK Betriebsanweisung Seite 5

•
Attention! Do not allow children to play
with polyethylene bags or packaging film.
Danger of suffocation!
•
•
•
•
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
USING THE HAIR CLIPPER
After unit transportation or storage at low
temperature, it is necessary to keep it for
at least two hours at room temperature
before switching on.
–
–
–
Attachment comb (6)
–
–
VT-2519.indd 5
For children safety reasons do not leave
polyethylene bags, used as a packaging,
unattended.
Never use the unit if the power adapter or
the adapter cord is damaged, if the unit
works improperly or after it was dropped.
Do not disassemble the unit by yourself,
if any malfunction is detected or after the
unit was dropped, apply to the nearest
authorized service center.
Transport the unit in the original pack-
age only.
Keep the unit out of reach of children and
disabled persons.
Unpack the unit completely and remove
any stickers that can prevent unit oper-
ation.
Check the unit for damages; do not use it
in case of damages.
Before switching the unit on, make sure
that your home mains voltage corre-
sponds to unit operating voltage.
Set the required hair length. To do this,
press the lock (7) and move the attach-
ment comb (6) to the corresponding posi-
tion.
Always switch the unit off before installing
and changing the attachment comb (6);
to do this, set the switch (3) to the position
«OFF» and take the power adapter out of
the mains socket.
– Pressing and holding the lock (7), remove
the attachment from the unit body.
– To install the attachment, insert it into the
groove on the unit body and then slide it
downwards as far as it will go, holding the
lock (7), and release the lock (7).
Lubricating oil
– Lubricate the blades after every use of
the hair clipper.
– Use only the oil (9) supplied.
– Do not use vegetable oil or oil that
includes solvents. Solvents will evapo-
rate, leaving thick grease that may slow
down the blades motion.
Using the hair clipper
– Insert the power adapter (8) jack into the
socket (1) and connect the power adapter
(8) to the mains.
– Switch unit on by setting the switch (3) to
the position «ON», the operation indicator
(2) will light up.
– After unit operation, switch the unit off,
setting the switch (3) to the position
«OFF», the operation indicator (2) will go
out.
– Disconnect the power adapter from the
mains and from the hair clipper.
Note:
Always switch the hair clipper off during
breaks in operation.
Before changing the attachment, switch the
hair clipper off and remove the power adapter
from the mains.
Hair cutting
– The hair should be clean and dry.
– Connect the unit to the mains.
– Before cutting hair, set the switch (3) to
the position «ON» and make sure that the
5
ENGLISH
03.10.2013 12:16:12