Symbol LS1203 Bedienungsanleitung Seite 9

Beeper
Sequence
Low/high beep
High/low beep
High/low/high/
low beep
Low/high/low/
high beep
Code 39 Buffering
High/low beep
3 beeps - long
high beep
Low/high/low
beep
Low/high beep
Host Specific
USB only
4 short high
beeps
Scanner gives a
power-up beep
after scanning a
USB Device
Type.
Indication
Input error, incorrect bar
code or Cancel scanned,
wrong entry, incorrect bar
code programming
sequence; remain in
program mode.
Keyboard parameter
selected. Enter value
using bar code keypad.
Successful program exit
with change in the
parameter setting.
Out of host parameter
storage space. Scan SET
DEFAULTS on page 86.
New Code 39 data was
entered into the buffer.
Code 39 buffer is full.
The Code 39 buffer was
erased or there was an
attempt to clear or transmit
an empty buffer.
A successful transmission
of buffered data.
Scanner has not
completed initialization.
Wait several seconds and
scan again.
Communication with the
bus must be established
before the scanner can
operate at the highest
power level.
9