Taking Off The Ceiling Cover Plate In An Emergency (Only For Trained Staff) - Kindermann compact2 series Installations- Und Bedienungsanleitung

The optional ceiling cover plate with T-profile frame (7466000152) or inserting the ceiling cutout
(600 x 600 mm, maximum thickness 15 mm, maximum weight 4 kg) will be mounted according to the illustration below.
When mounting we recommend to provide additionally four holes of 5-6 mm to the corresponding locations of the hangers
in the ceiling cut, which can be sealed from below with a dummy plug, that the plate in an emergency can be removed from below.
4.4 Taking off the ceiling cover plate in an emergeny (only for trained staff)
If the lift can't be lowered in case of a power cut or a technical problem, you can get access to the unit by taking off the
ceiling cover plate. Take cake care that the plate does not drop in an uncontrolled way.
Now the problem can be analysed.
After disengaging the two carrying ropes the lift can be manually lowered by 20 cm.
Attention: Secure the lift with a prop.
!
für Befestigung der Trageseile am Tragrahmen von unten lösen (Schrauben M4), die Winkel nach oben
10 Procedure: Loosen the two mounting plates
für Befestigung der Trageseile am Tragrahmen von unten lösen (Schrauben M4), die Winkel nach oben
and disengage them. 10
Now the lift can be lowered by 20 cm until it is secured by the carrying ropes again
Now the screws of the projector holder and the cross bar can be loosened for taking out the projector.
In the same maintenance position the condensor motor could be exchanged, too.
Contact our service team for further instructions.
11
to which the carrying ropes are attached (screws M4), move them upwards
10
10
10
im Deckenausschnitt zusätzlich vier
im Deckenausschnitt zusätzlich vier
11
11
27