User Interface - Velleman DVR8T4 Schnelleinstieg

6.

User Interface

Refer to the illustrations on page 2 of this manual.
6.1 DVR Access
1. Connect a USB mouse to the mouse port  on the DVR front panel, and check if there is a mouse icon
on the screen, indicating the USB mouse is detected properly.
2. Move your mouse to enter the DVR password with the password keypad. The default user name and
password are both admin.
Change the user name and password. To do so, see the following video:
https://youtu.be/o14ai8GZDiQ.
Log in with the admin account and create a new account with supervisor rights on the recorder. Do not
o
take admin as user name or password.
Log out on the recorder.
o
Log in with the new account.
o
Delete the default admin account.
o
Do not use ports 80, 8000, 8080 or 9000 on the recorder, this for security reasons.
Use the Eazy Networking function instead of port-forwarding. To see how to use the Eazy Networking
function, refer to following video: https://www.youtube.com/watch?v=J7XbGAtjI10.
6.2 Live Page
DVR Status
key lock
overwrite on
internet disconnected
local connection
USB flash drive/device connected
IVS on
timer recording on
PTZ mode on
sequence mode on
Channel Status
original size
live audio on
recording
record mode: Frame
virtual fence event
V. 01 – 15/01/2019
DVR8T4
fit to screen
audio off
human detection
event
record mode: Field
one way pass event
6
1. system time
2. DVR status bar
3. available HDD capacity
4. channel status bar
key unlock
overwrite off
internet connected
USB mouse connected
no USB device connected
timer recording off
PTZ mode off
sequence mode off
DCCS connection OK
audio playback on
motion event
record mode: CIF
scene change event
DCCS connection
failed
audio playback off
alarm event
©Velleman nv