Velleman DVR8T4 Schnelleinstieg Seite 5

3. Fasten the hard disk to the bracket by securing the screw on the bracket.
4. Replace the top cover and fasten the screws.
Type 2
1. Remove the top cover and find the hard disk connector and bracket in the device.
2. Get a compatible hard disk. With the PCB side facing down, insert the hard disk in one of the hard disk
connectors.
3. Align the screw holes on the base (1) and the hard disk (2). Then, fasten the hard disk on the base with the
supplied screws from the bottom side of the recorder.
4. Connect the data bus and power cable for the hard disk.
5. If any, remove the protective film on the bottom of the recorder to ensure heat dissipation.
V. 01 – 15/01/2019
DVR8T4
5 ©Velleman nv