Velleman DVR8T4 Schnelleinstieg Seite 4

5. Installing the Hard Disk Drive (HDD)
Before the DVR is powered on, make sure you have installed a hard disk, connected at least one camera and an
HDMI monitor. The DVR is designed to automatically detect the video system of the connected cameras (NTSC
or PAL). To make sure the system detection is correct; please check if the cameras are connected to the DVR
and power-supplied before the DVR is powered on.
Notes:
 Only use a purple Western Digital hard disk designed for surveillance to ensure proper operation.
 It is not recommended to use an audio/video 24/7 hard disk in this device.
 It is recommended to clear all data on a new hard disk after the DVR is powered on, and to set the date
and time correctly to make sure that recorded data are not mixed with older data. For details on clearing all
data, refer to Clearing the Hard Disk.
Type 1
1. Remove the top cover and find the hard disk connector (1) and bracket (2) in the device.
2. Get a compatible hard disk. With the PCB side facing down, insert the hard disk in one of the hard disk
connectors.
V. 01 – 15/01/2019
DVR8T4
4 ©Velleman nv