Date And Time Setting; Time Setup - Velleman DVR8T4 Schnelleinstieg

8.2 Switching On
Caution:
 Before the DVR is powered on, make sure that (1) the cameras are connected and powered on for the
detection of the camera video system to be correct, and (2) an HDMI monitor is connected to the DVR for
correct video output detection.
 This device should be operated only with the type of power source indicated on the manufacturer's label.
Use only the included adapter.
To switch on the DVR:
1. Plug the DC output connector of the included power adapter into the power input (DC 19V) at the back of
the DVR.
2. Plug the included power cable into the adapter input connector and plug the other end into the mains.
3. Switch on the DVR with the power switch on the back of the device. The power LED
the DVR.
Note: To ensure that your DVR works constantly and properly, it is recommended to use an UPS
(Uninterruptible Power Supply, not incl.), for continuous operation.
8.3

Date and Time Setting

Before operating your DVR, please set the date and time on your DVR first.
Note: DO NOT change the date or time of your DVR after the recording function is activated. Otherwise, the
recorded data will be disordered and you will not be able to find the recorded file from backup by time search.
If users change the date or time accidentally when the recording function is activated, it is recommended to
clear all HDD data, and start recording again.
Note: When using the DVR for the first time, leave it powered on for at least 48 hours continuously after the
date and time is set correctly. It prevents DVR time from resetting if the DVR power is disconnected. If the DVR
time resets after power disconnection (for example caused by a power outage), the internal battery may run
down. In that case, you have to replace the internal battery. Please refer to the appendices in the full user
manual for more information.
1. Right-click to enter the DVR password with the password keypad. The default administrator password
is admin.
The status will change from
2. Right-click to show the main menu, and select
GENERAL

TIME SETUP

DAYLIGHT
EaZy
EXIT
8.4 Clearing the Hard Disk
It is recommended to clear all data in the hard disk when using this DVR for the first time to ensure the
recorded data are not mixed with other data previously saved in the same hard disk.
1. Right-click to show the main menu, and select
V. 01 – 15/01/2019
DVR8T4
(key lock) to (unlock).
(QUICK START) > TIME SETUP to set the date and time.
QUICK START
DATE
TIME
NTP SERVER
FORMAT
SYNC PERIOD
GMT
(SYSTEM) > SYSTEM INFO > CLEAR HDD.
10
2009 / NOV / 17
15 : 35 : 53
pool.ntp.org
Y/M/D
OFF
(GMT + 8:00) TAIPEI
lights on the front of
©Velleman nv