Technical Information; Technical Data - AEG A62710GNW1 Benutzerhandbuch

66 www.aeg.com
9. Refit the door.
10. Refit and screw both lower hinges.
11. Refit the plinth (8).
12. Remove the handle. Unscrew the top
handle bracket from the handle rod
(1). Unscrew the bottom handle
bracket from the door (2).
1
13. Unscrew the top handle bracket from
the door (3).
14. Re-screw the handle bracket on the
door (4). Turn the handle bracket with
the handle and screw them to the
door (5) and the fitted handle bracket
(6).
4

10. TECHNICAL INFORMATION

10.1 Technical data

Height
Width
Depth
Rising time
5
4
2
5
15. Re-insert the door on the lower hinge
pivot.
16. Re-insert the door on the upper
hinge pivot slightly tilting the door.
17. Screw the lower hinges.
18. Stand the appliance upright.
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect it
to the power socket.
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal adheres
3
• The door opens and closes
If the ambient temperature is
cold (i.e. in Winter), the gasket
may not fit perfectly to the
cabinet. In that case, wait for
the natural fitting of the
gasket. In case you do not
want to carry out the above
mentioned operations,
contact the nearest After Sales
Service Force. The After Sales
Service specialist will carry out
the reversibility of the doors at
your cost.
6
mm
mm
mm
Hours
to the cabinet.
correctly.
1850
595
658
20