AEG A62710GNW1 Benutzerhandbuch Seite 63

Problem
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The FROSTMATIC function
is switched on.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The FROSTMATIC or COOL-
MATIC function is switched
on.
The appliance is in demon-
stration mode.
The appliance is not level-
led.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
The door has been opened
often.
The FROSTMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.
ENGLISH
Solution
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FROSTMATIC
function".
The compressor starts after a
period of time.
Attach the melting water
outlet to the evaporative
tray.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC
function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli-
ance.
63