Closing The Door; Installation; Rear Spacers - AEG A51100TSW1 Benutzerhandbuch

28 www.aeg.com
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.

8.2 Closing the door

1. Clean the door gaskets.

9. INSTALLATION

WARNING!
Refer to Safety chapters.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
T
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Authorised Service
Centre.

9.2 Rear spacers

In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
1. Fit the spacers into the holes. Make
sure that the arrow (A) is positioned
as shown in the picture.
1
A
2. Turn counter-clockwise the spacers
through 45° until they lock into place.
9.3 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
2
45°
45°
2