Operation; Control Panel; Switching Off; Temperature Regulation - AEG A51100TSW1 Benutzerhandbuch

22 www.aeg.com

3. OPERATION

3.1 Control panel

Green Indicator Light
1
Red Indicator Light
2
Temperature Regulator
3
3.2 Switching on
Leave the appliance to stand upright for
4 hours after installation.
Insert the plug into the wall socket.
1. The Green Indicator Light will light
up and remain lit until the appliance
is switched off.
2. Leave to run for 8 hours to allow the
correct temperature to be reached
before placing food inside.
The Red Indicator Light will stay on
until the correct temperature is
reached.
3. When the appliance has reached the
set temperature (the Red Indicator
Light has gone out) adjust the
Temperature Regulator according to
the quantity of the stored foods.
1 2
Half Loaded position
4
Full Loaded position
5
A few hours after starting up
the Red Indicator Light will
go out to show that the
correct temperature has
been reached for the setting
chosen and will stay out to
indicate that everything is in
order. It will come on if the
freezer temperature rises
unduly for instance, after
opening the freezer door or
placing food inside the
cabinet, but the light should
go out again when the
temperature returns to the
correct storage level.

3.3 Switching off

1. To turn off the appliance, disconnect
the mains plug from the wall socket.
2. To disconnect the appliance from the
power, disconnect the mains plug
from the wall socket.

3.4 Temperature regulation

The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as
follows:
3
5 4