Replacing The Lamp; Closing The Door; Technical Data - AEG A72900GNW0 Benutzerinformation

36

Technical data

Problem
The appliance does not
operate.
The lamp does not work.
Door interferes with venti-
lation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

The appliance is equipped with a longlife LED light.
Only service is allowed to replace the lighting device. Contact your Service Center

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The door has been open to long.
The appliance is not levelled.
The appliance is not levelled.
Height
Width
Depth
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Refer to "Replacing the lamp".
Close the door.
Refer to "Levelling".
Refer to "Levelling".
A72900GNW0
1800 mm
595 mm
623 mm
12 h
230 V
50 Hz
Solution
A72900GNX0
1800 mm
595 mm
623 mm
12 h
230 V
50 Hz