Closing The Door; Installation - AEG A72930GSX3 Benutzerinformation

Problem
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.

7.2 Closing the door

1. Clean the door gaskets.

8. INSTALLATION

WARNING!
Refer to Safety chapters.
8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Possible cause
The appliance is in demon-
stration mode.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
Food products placed in
the appliance were too
warm.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
The FROSTMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Climate
class
SN
N
ST
T
ENGLISH
Solution
Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Allow food products to cool to
room temperature before stor-
ing.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FROSTMATIC func-
tion".
Make sure that there is cold air
circulation in the appliance.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
31