Briggs & Stratton; Starting The Engine; Driving The Machine; Cutting And Automatic Grass Collection - Gianni Ferrari GTS 200 Technisches Handbuch

7.1 BriGGs & strAttoN
RIF. DESCRPTION
1 12V battery
2
Motor
3
Headlights
4 Clogged oil filter light
5 Headlights switch
6
Ignition switch
7
Fuse 20A
8 Fuse 15A
9 Fuse 10A
10
Full load buzzer hopper
11
Hourmeter
12 Motor connector
13 Differential electric valve

8. stArtiNG tHE ENGiNE

1) Take your place correctly on seat.
2) Make sure that P.T.O. lever is entirely disengage
3) Make sure that the parking brake in enturely
4) Set engine choke control to for cold starts and turn the ignition key to the "ON" position.
5) Turn the ignition key onto the symbol to start the motor
6) Slowly return choke to run position once the engine has started.
7) with temperature under 0°C keep the motor at medium speed for at least 5 minutes

9. driViNG tHE MACHiNE

1) Set throttle lever.
2) Disengage the parking brake.
3) Selelect the desired speed though the pedal fitted on the right side.
4) By moving the steering wheel one steers the back wheel.
N.B.: To stop the machine, just release the forward or reverse pedal; once stopped, engage the parking brake.
IMPORTANT: To being drive at slow speed, for safety reasons make sure that people and ani-
mals are at least 3 meters away

10. CUttiNG ANd AUtoMAtiC GrAss CoLLECtioN

11. stoPPiNG tHE ENGiNE

1) Stop the machine.
2) Declutch the PDP lever.
3) Engage the parking brake.
4) Full lower the equipment by means of the specific lever.
5) Make sure that the basket is completely draw in.
6) Reduce the motor revolution on minimum.
7) Turn the ignition key from "ON" position to "STOP" position.

12. tANK FiLLiNG

Only fill the tank in open air or in a sufficiently ventilated room. The engine must be turned off and no flames or sparks
should be made. Check that carburant is the one indicated by the label on the tank.
WARNING: CARBURANT IS HIGHLY INFLAMMABLE.
KEEP THE CARBURANT IN JERRYCANS. FILL THE TANK WITH PETROL ONLY IN OPEN AIR AND DO NOT
SMOKE DURING THIS OPERATION. ADD CARBURANT BEFORE STARTING THE ENGINE. NEVER REMOVE
THE TANK LID NOR ADD CARBURANT WHEN THE ENGINE IS WORKING OR IS HOT.
In case of carburant escape, do not try to start the engine but move the machine away from the place where the escape
took place and avoid creating ignition sources until carburant fumes have dissipated. Replace the correct lids on the
tank and the jerrycan. Never store the machine with carburant in the tank inside a building where the fumes might reach
some free flames or sparks. Let the engine cool down before storing the machine in any closed environment.
See figure 7.1
See figure 8.
engaged.
See figure 9.
See figure 12.
14 Differential locking device switch
15
Basket closed microswitch
16
Hopper full switch
17 Parking brake microswitch
18 Starting relay
19
Seat stop relay
20 Hourmeter relay
21 Relay motor arrest open basket man to earth
22 Clogged oil filter sensor
23
Temp. Sensor
24
Fan of cooling
25 Seat switch
26 P.T.O. lever switch
See figure 10.
EN
19