Oven Illumination; Cleaning And Maintenance; Preparation For A Prolonged Out Of Use; Instructions In The Event Of Faults - Lotus CF4-68ET Installations- Und Gebrauchsanweisungen

To turn the light on inside the oven press the button with the symbol.
With the light on inside the oven you can keep a check on the food while it is cooking through the glass door without
having to open it..
Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
Cleaning the crystal
The crystal must be cleaned with degreasing liquids, acids containing vinegar and lemon, suitable for cleaning ceramic
and crystal. It is advisable to carry out this operation when the crystal is not completely cold, so that spilled food,
burned grease, etc. can be softened using a damp cloth and removed whilst still warm with an ordinary scraper, in order
to avoid damaging the crystal surface.
Do not use abrasive or corrosive detergents.

PREPARATION FOR A PROLONGED OUT OF USE

Thoroughly clean and dry the appliance as per instructions, switch off at the mains.
If a fault develops, turn off the appliance, switch off at the mains and call the technical assistance service.
•
Switch off the appliance.
•
Remove the glass light cover.
•
Unscrew the light bulb.
Replace with a bulb having the following characteristics:
•
Heat resistant up to 300°C.
•
Wattage 15 W.
•
Volts: according to model.
GB

OVEN ILLUMINATION

CLEANING AND MAINTENANCE

INSTRUCTIONS IN THE EVENT OF FAULTS

REPLACING THE OVEN LIGHT

IE
35